I mentioned earlier this week that I’ve been on the hunt for the perfect camera bag for my recently acquired Sony Nex-5 and today I’m back with the perfect custom solution that you can make out of any bag!
Here’s what you’ll need:
- Bag or purse large enough to hold your camera and needed accessories
- Fabric of choice
- Coordinating thread
- Craft glue
- Sewing machine
- Iron & ironing board
Let’s start with the bag, my bag just happens to be a vintage camera bag that I acquired from my photo-loving Grandad. (Thus the title of this post.) Like most bags, it didn’t have quite enough padding so the first step is adding enough cushion to protect your camera.
Start by measuring the length and width of the bottom and both sides of your bag. Mine was 3″ wide by 26″ long. I added 1″ to the width and 6″ to the length (3 per side) and cut the needed dimensions from my fabric. With right sides together, pin your sleeve with the pins running perpendicular to the long edge.
Next, stitch along the long edge. . . .
. . . . and turn the sleeve right side out.
You then want to cut strips of batting to stuff into your sleeve. The thinnest batting I could find was 1″ and I wanted something a little thinner so I tore the batting in half to make 2 1/2″ layers.
Next it’s time to cut strips of the batting. Since my sleeve was 3″ wide I cut strips that were 2 3/4″ so they would fit snuggly inside.
Next, on one end only, create a finished edge by rolling the unfinished edge inward. Press the new seam.
Double stitch your finished edge and attached a piece of velcro. It doesn’t matter which side of the velcro you attach to the sleeve, I chose the ‘hook’ side.
Now it’s time to fit your sleeve to your bag and make measurements for the second unfinished edge.
As you can see, I had to trim several inches off of my sleeve. Trim your fabric and batting to fit making sure to cut the batting about 1″ shorter than your fabric so you’ll have enough fabric to turn under. Repeat the finished edge process on this end, double stitching the fold and attaching the velcro.
Now for the back piece. I cut a rectangle that was slightly wider that the back of my bag and double the length. Here it is folded over.
Then, cut a piece of batting that is exactly the size of the back of you bag.
Insert the batting inbetween the folded fabric, like a pocket and stitch around the 3 open edges.
Now you’re ready to assemble! I put the back piece in first with just a small piece of velcro at the top with the idea that the sleeve would mostly hold that piece in place.
To attach the sleeve, cut a piece of ‘loop’ velcro, line it up with the hook piece on the fabric. Attach the adhesive side to the bag and let it set overnight.
Attach the other end of the sleeve and you’re done!
I made another shorter sleeve to serve as a divider between my camera and extra lens.Enjoy your new custom bag!